PMA KS50-1 Temperature & Process Controller with Programmer
The universal KS 50-1 temperature controller is intended for precise and cost-effective control tasks. The instrument provides simple 2-point (on/off) control, continuous PID control or 3-point stepping control. The process value signal is connected via a universal input. A supplementary analog input can be used for heating current measurement or as an external set-point input.
Request a Quote
Availability:
In stock
SKU
WC01600W
The universal KS 50-1 temperature controller is intended for precise and cost-effective control tasks. The instrument provides simple 2-point (on/off) control, continuous PID control or 3-point stepping control. The process value signal is connected via a universal input. A supplementary analog input can be used for heating current measurement or as an external set-point input.
The KS 50-1 has three process outputs that can be 3 relays or 2 relays plus a universal output. This universal output can be used for operating a solid-state relay, a continuous current/voltage output or to energize a two-wire transmitter. Optionally there are two additional optocoupler outputs that can be used freely.
Product Features:
The KS 50-1 has three process outputs that can be 3 relays or 2 relays plus a universal output. This universal output can be used for operating a solid-state relay, a continuous current/voltage output or to energize a two-wire transmitter. Optionally there are two additional optocoupler outputs that can be used freely.
Product Features:
- -Universal continuous/switching version, i.e. reduced stocks
- -100ms cycle time, i.e. also suitable for fast control loops
- -20ms as shortest pulse for very fast / strong actuators
- -Freely configurable analog output, e.g. as process value output
- -Customer-specific linearization for all sensors
- -Settings can be blocked via password and internal switch for high security
- -Extended temperature range up to 60 °C allows mounting close to the process
- -Easy 2-point or offset measurement correction
- -Emergency operation after sensor break by means of the "output hold" function
- -Logical combination of digital outputs, e.g. for general alarm
- -Programmer with 10 segments and "end" signal
- -RS 422/485 Modbus RTU interface
- -Built-in transmitter power supply
- -Splash-water proof front (IP 65)